Make Furnace Maintenance A Part Of Your Regular HVAC Repair In Boulder CO

Including furnace maintenance as a part of the schedule HVAC repair Boulder CO will ensure your heating system stays fit for a longer life. Your service technician for HVAC repair will advise for the same. There are several things that you can do yourself to troubleshoot and repair the furnace.

Furnaces can use different types of fuels, like, gas, oil or electric but the basic troubleshooting and repair steps remain similar to each other.

Clean Your Furnace During Furnace Maintenance In Boulder CO

A clean furnace ensures high efficiency and correct utilization of the fuel. Furnace filter needs to be cleaned on a monthly basis beginning at the start of the heating season. To clean the filter, take it out and hold it against the light, if it is clogged, replace the filter with a new one.

Make sure to clean the blower assembly, belts and housings. Any openings in the blower and the fan cage can get clogged with dirt and needs to be cleaned. Remove the filter panel or the one on the front of the furnace, slide out the fan unit if needed to access the blower. Use a small brush, a toothbrush will work, to clean the fan blades. Use vacuum cleaner to remove the dirt and debris. Wipe the housing clean.

Lubricate Your Oil Furnace Motor during HVAC Repair

Motors usually come permanently lubricated and sealed by the manufacturer. In such cases, extra lubrication is not required. But is your oil motor has covered oil ports near the motor shaft then an annual lubrication is necessary. Do not use all-purpose oil for this but you can get 10-weight non-detergent motor oil from a hardware store.

Remove the access plate to reach the ports and add few drops of the oil to each port. Blower shaft ports need to be lubricated as well. Some blowers have grease cups and these cups need to be filled with the lubricant available from automotive stores.

Replace The Furnace Belt During Furnace Maintenance

A broken or worn out belt is often the cause for a non-operational blower. In such cases the furnace belt must be replaced.

The first step when replacing a furnace belt is to ensure that the power to the unit is turned-off. You will need to access the lower part of the furnace to reach to the belt. Remove the access panel by lifting it up or by removing screws from the top if it has any. The motor is secured to the furnace with the mounting bolts and slide the motor a little. Loosen these bolts and pull the belt off the pulley. Place the new belt over pulley and pull the motor back. Secure the motor with the mounting bolts, replace the access panel and turn the power supply back on.

Scheduling a regular furnace maintenance will solve all your maintenance and operational issues.

Author: Victoria Garcia

Share This Post On

Submit a Comment

Your email address will not be published. Required fields are marked *